I needed three servos for the rudder and split elevators that needed to be small enough to hide in the fin and stabilizer and have enough torque to do the job. The DS 100DLHV were the only servos of any manufacture that fit the bill. A high quality servo and great service from ProModeler.

I've now used ProModeler DS100HV and DS150HV and I have to say these are the only servos I will buy for my R/C planes. They are extremely strong and there is NO slop in the centering or gears. As for strong, I crashed a 3D balsa plane and the servos were undamaged. Always in the past a crash resulted in stripped gears in my other brand micro servo. DS100HV are the answer!

Typical competitors always develop slop in the gears of metal gear servos because of the case design but ProModeler servos have NO slop. It's amazing, you should try them.

They are wide voltage servos too - I have flown them on the 5V BEC settings and up to 8V. Also on 6.6V LiFe packs. Sure, they are a little slower at 5V compared to 8V but in the air I was not able to notice any difference.

Don't hesitate, give them a try!

 

Quiet, strong, precise, reasonable speed. I like it!

 

This servo is fantastic! I love the small size and smoothness this servo offers. I see myself upgrading all of my servo's to ProModeler over time. They are a great value.

I'm running DS100DLHV servos in my Extreme Flight 52" Velox on 2S LiPo (7.4V) and they are great. No gear lash at all, very smooth and strong. An excellent and economical choice, much better than other servos on the market.

The old postal system is definitely getting slower in OZ as my order only arrived 15th May 2019. Order shipped 27th April via UPS.

Good arrived in perfect condition. Loved the little extra stickers and stubby holder.

Servos look fantastic and hope to use them in the next two months.

Thank you for your very prompt service.

I had to replace one servo on my 52" Slick. On Doc Austin's recommendation I installed a set of ProModeler DS100DLVH. Wow for the high quality! I like how they are water resistant so no worries when I fly off the wet grass because of early morning dew. And the high range of 8.4V is a plus because this allows me to power the RX with a small 2S lipo.

I installed four ProModeler DS100DLHV submicro servos in my new 3DHS 52” Edge 540. It’s a great flier, zero trim from the start. That's a first for me. Plane flies rock solid in all attitudes. I am only running them at 6 volts but they hold their position perfectly and have very little deadband. I also like that they use 4 mounting screws. These are solid servos, very fast and strong and I definitely recommend them.